Beta Riders Club Discussion Forum

I've got a 2016 300 two-stroke and gave up on the OEM speedos after having two of them fail due to the same water ingress issue you describe. Nowadays I just use a navigation app on my GPS-enabled phone to track distance and don't have any need to monitor ...

So, my 2016 speedo finally went out for good. I've been able to disassemble and clean out multiple times and get it functional but not this time. Took water in, big surprise I know. I did figure out it was not the body seam but ...

... illuminated on the dash. To turn that off, instead of cutting the pink wire, I simply unplugged the 4 wire mini connector running into the dash/speedo unit. This turned off the Check light and Icon and left the mileage portion visible again without having to cut any wires. As long as you are ...

... oil and gas. However, if the warning light is annoying you, you can easily disable it by snipping the pink wire with the purple stripe at the speedo, as show in the pic below. That wire is controlled by the ECU and serves solely to illuminate the check engine light, which is only illuminated ...

... backwards, I was missing a tire valve cap, the rear wheel was not a cush drive hub, and the 320mm brake adapter bracket doesn't fit with the speedo reed sensor. The Cycle House has offered to take care of me, but this has been a pain. I always change my own tires, so I installed the front ...

mtdirtbag wrote:If your dealer is close by, check with them they may have a non-working one that you can swap your internals to. I had a broken battery cover and stopped by my dealer and they replaced it with one from a bad computer, best part was that it was free.

It's worth a try.....

If your dealer is close by, check with them they may have a non-working one that you can swap your internals to. I had a broken battery cover and stopped by my dealer and they replaced it with one from a bad computer, best part was that it was free.

2nd pic-



2nd pic-

... A while ago I ended up pile driving some trees with my 2018 300RR.....smashing my front plate into the triple clamps and breaking the two speedo mounts to the speedo plate. Has this happened to anybody else? I'm thinking of trying some epoxy for a "fix" before purchasing a replacement. ...

All of my comments and suggestions in this thread are based on my experiences with the OEM speedo manufactured for Beta by Trail Tech on 2015-2017 models. Beta has since changed speedo manufacturers twice and I have no insight into the design and wiring etc. for these. ...