by JoeMaico » Wed Jan 20, 2021 7:16 am
Depending on what you are doing - you need several parts. If you just want the seal and o-ring, they are listed below. But, if you are going through all of the effort to get to it, I would advise new gaskets, locking washer, and Woodruff key as well. This list is for a 2016 300, you did not state what bike you have. Also, I would buy 2 primary seals in case you screw one up. They are tricky to get in unless you have a driver of the correct size. I did not, but I froze it and was able to slowly work it in with a flat piece of steel and a small hammer. Others have suggested taking the seal to a hardware store and getting a piece of PVC that fits the outer circumference and use it as a driver. If I do it again, that is what I will do.
joe
Clutch Cover Gasket - 26.01.005.00.00
Water Pump Gasket (outer) - 26.01.035.00.00
Water Pump Gasket (inner) - 26.01.036.00.00
Water Pump Tube O-Rings (need 2) - C02.06.052.00.00
Water Pump Oil Seal - 10.43720.000
Clutch Tab Locking Washer - 06.03.064.00.09
Primary Gear Seal - C02.01.001.00.00
Primary Gear Spacer - 026.02.009.00.00
Primary Gear O-Ring - 10.66620.000
Woodruff Key Primary Side - 12.46151.000