Hi,
Im new to this so here goes...
So after my bike riding poorly for the past 3-4 outings i did my research and found out that the oil injector on the RR300 is very temperamental and so i have done what i think necessary to be able to bypass the pump and and mix direct in to the tank.
This is what i did...
1- removed the blue electrical connector plug from the oil pump
2 - taped up the connector and left under seat
3 - removed oil line from the pump and from the manifold nipple (protected nipple with short off cut of the oil line and folded over and zip-tied)
Should this now be good to run with premix in the tank and start running properly again or is there more i need to do?
can someone show me where the oil level sensor is and the TPS sensor connector is as well so that i can turn off the warnings on the screen.
Cheers!
Morgan