Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.
by humanoid » Thu Jan 02, 2020 10:45 am
Can anyone get me a measurement on the powervalve flapper for a 2018 25/300rr?
I think I have an 18 cylinder with 2016 flappers...
it's not fitting together correctly(bearings not fully seated, when bearing set screws are torqued to spec(10nm) the valve is binding/stuck)
-
humanoid
-
- Posts: 42
- Joined: Sat Feb 27, 2016 8:07 pm
by humanoid » Thu Jan 02, 2020 2:14 pm
-
humanoid
-
- Posts: 42
- Joined: Sat Feb 27, 2016 8:07 pm
by babelfish » Thu Jan 02, 2020 3:43 pm
FWIW I heard from my dealer that the exhaust valve had been redesigned on later models. He described it as tighter with more precision.
-
babelfish
-
- Posts: 31
- Joined: Mon Apr 29, 2019 11:01 am
by humanoid » Thu Jan 02, 2020 4:06 pm
looks like it was redesigned in 2018 to a single piece valve vs the 17/older 2 piece.
looking at fiche only the valve/flapper has changed. boosters/rods/bearings etc all the same.
Iam guessing the 2018 flapper will be like 2mm shorter
-
humanoid
-
- Posts: 42
- Joined: Sat Feb 27, 2016 8:07 pm
Return to Engine - 2 Stroke
Who is online
Users browsing this forum: No registered users and 123 guests