Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.
by betascott » Tue Aug 10, 2021 4:41 pm
I was changing clutch fluid (gravity bleed).somehow I got air trapped in.i got a syringe and tried back bleeding.but I have screw loose cap off master cylinder but can't push it up.ive watched videos but can't figure it out. What am I doing wrong. Thanks for the help
-
betascott
-
- Posts: 12
- Joined: Sun Jul 04, 2021 8:07 am
by Dirt ninja » Wed Aug 11, 2021 10:15 pm
I recently had the same thing happen to me. I didn't back feed the system. I just kept bleeding fluid, filling it with fluid and jammed the piss out of the clutch lever, until I bleed the air out. Just gravity drained and filled the system.
-
Dirt ninja
-
- Posts: 22
- Joined: Fri Feb 15, 2019 7:41 am
by Rob578 » Tue Aug 17, 2021 8:27 am
Order the $54 reverse bleeder from Amazon.
As an alternative try taking the slave cylinder completely off and pushing the piston all the way back in and filling it with fluid, put the lines back on, then try bleeding it.
-
Rob578
-
- Posts: 90
- Joined: Wed Mar 25, 2015 11:31 am
by betascott » Sun Aug 29, 2021 11:01 am
Fyl if anyone else has the same problem. had to end up taking it to the shop.master cylinder was bad.
-
betascott
-
- Posts: 12
- Joined: Sun Jul 04, 2021 8:07 am
Return to Engine - 2 Stroke
Who is online
Users browsing this forum: No registered users and 52 guests