Page 1 of 1

390 RR-S smoke at cold start up

PostPosted: Sun Oct 15, 2017 7:42 am
by jlamb4483
I'll start the bike and let it idle for a few mins to warm up. I'll usually blip the throttle a few times once it's above 120 degrees and notice a bit of white smoke out the tail pipe. I thought it was just from running rich but thought that is usually black smoke? I haven't noticed the oil level drop. It only happens after start up that I know of, once riding and warm it doesn't do it.

Bike has 18 hours on it. Changed the oil at 3 and 9 hours. Will check the valves just after 20h - still starts right up. I kept it under low rpm under the 3 hours, and under 75% power before 12 hours for the break in. At the same time, I didn't "baby" it for it's break in, just rode it normal.

Any suggestions are appreciated.

Re: 390 RR-S smoke at cold start up

PostPosted: Sun Oct 15, 2017 7:53 am
by jlamb4483
I should also add that the oil level is not above the upper hash mark on the sight glass. I have not noticed my coolant level drop either.

Re: 390 RR-S smoke at cold start up

PostPosted: Sun Oct 15, 2017 4:00 pm
by Marty Moose
Not unusual after idling from cold long as it goes away.

Re: 390 RR-S smoke at cold start up

PostPosted: Sun Nov 12, 2017 1:35 pm
by jlamb4483
After talking with my dealer, they recommended letting it idle for 30 secs to a minute then hop on and ride around easy to warm it up (just like we do with our cars & trucks we drive). I don't see any smoke so, so i'll keep warming the bike up this way.

I did top off some motor oil so I'm assuming it was burning oil. Does anyone have a reason while it would do this warming up idling rather than under a small load riding around?