Conditions:
- Passive reset was performed yesterday to set up for today's conditions
Cold, warming to 40F by the time it stalled
Wet, but not muddy
Several puddle crossing, nothing deeper than the top of the engine case (not near the air box/filter)
- Battery (good, cranks and cranks and cranks...)
Kill switch (cranks when out, won't crank when engaged)
Fuse (swapped spare in, still won't start)
Jiggled wires and plugs behind the number plate while cranking, no start
Unplugged and checked all plugs behind the number plate, reinstalled with confidence; no start
Plug boot is installed
Fuel pump cycles (can smell gas when holding throttle open during cranking)
What else should I consider? Can I troubleshoot/bench check the ECU?