by F5 Dave » Fri Mar 17, 2023 1:25 pm
I cant see those pics in last post but; I have a 21 XTrainer. I'd bet that section of wiring is the same.
I bought a ktm start switch as shown. I reused that plug, but needed to swap the two left pins for the two right ones. Actually there was a loop on the other two which would have the kill switch pushed the whole time when plugged into the Beta loom once swapped. So I cut it and with solder and heatshrink joined the ends to a generic YZ style kill switch.
Lights on different connector. I just wanted waterproof.
To remove the pins You can mess around with tiny screwdrivers pressing the sides of the contacts, but it's far easier with the proper tool, which is just a thin piece of tube. You could probably make one by drilling a hole in a small rod. But I'd just bought a multi keyring full of every extraction tool from Aliexpress for pennies and was looking for something to test.
21 XTrainer