How to remove the bearning from the lower triple clamp?

Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing.

How to remove the bearning from the lower triple clamp?

Postby Arielto » Fri May 27, 2022 11:49 am

Hi,
I am replacing the triple clamp on my 2021 250rr and need to carry over the bearings from the existing triple clamp.
The bearing on the lower tripple clamp sits very tight around the axle and am not sure what would be the way to remove it without causing any damage.

Your help and recommendations is greatly appreciated.
Thank you!
Ariel
Attachments
bearing2.jpg
bearing2.jpg (35.77 KiB) Viewed 2172 times
Arielto
 
Posts: 2
Joined: Tue Jun 08, 2021 5:30 am

Re: How to remove the bearning from the lower triple clamp?

Postby F5 Dave » Fri May 27, 2022 10:34 pm

Buy a new set.. removal is destructive. I don't see a way of not distorting the cage without some tricky puller I've never seen . Usually this isn't a concern as you are replacing a buggered set.
21 XTrainer
F5 Dave
 
Posts: 66
Joined: Sat Oct 16, 2021 12:37 pm
Location: New Zealand

Re: How to remove the bearning from the lower triple clamp?

Postby Darkside » Sun May 29, 2022 9:07 am

the only way I can think of is to press the stem out of the bearing and clamp together
Randy
2018 390 rrs, 2014 300 rr re, 2010 ktm 450 exc
Darkside
 
Posts: 449
Joined: Tue Jul 30, 2013 12:53 pm
Location: SF Bay Area


Return to Chassis & Body

Who is online

Users browsing this forum: No registered users and 38 guests