Page 1 of 1
Lower handlebars for sub mount
Posted:
Wed Dec 07, 2016 4:53 pmby Volitans
Anyone know what bars i need to get in order to go back to stock height when installing scott damper With brp submount?
Re: Lower handlebars for sub mount
Posted:
Wed Dec 07, 2016 8:36 pmby ricoyam
Volitans wrote:Anyone know what bars i need to get in order to go back to stock height when installing scott damper With brp submount?
I think BRP or Scotts should have the best idea. I keep thinking about contacting them but always forget during the day. I'm getting used to the 60's chopper ergonomics now too.
Re: Lower handlebars for sub mount
Posted:
Thu Dec 08, 2016 12:31 amby cluffie
protaper carmichaels are within a few mm's.
Re: Lower handlebars for sub mount
Posted:
Thu Dec 08, 2016 10:23 amby Volitans
Tks guys,
I talked to scotts/brp and they did not know
The stock size so they coudlnt recommend.
I will have a look at the protaper
Re: Lower handlebars for sub mount
Posted:
Sat Dec 10, 2016 6:54 amby Volitans
They have the steering damper low version and the pastrana. Has anyone tried these?
Re: Lower handlebars for sub mount
Posted:
Sat Dec 10, 2016 8:34 amby jump64
I recently went with the EVO Steering Damper low bars and like them. Comparing to a buddies bike without the sub mount, bars are about the same height. BRP worked directly with ProTaper for this bend to get the bar back to stock height.
https://www.youtube.com/watch?v=CTYqw50WhOw
Re: Lower handlebars for sub mount
Posted:
Sat Dec 10, 2016 1:33 pmby Showtime477
I have the Renthal McGrath low bend and I like them. The only downside is there is not much room to mount up hand guards or map switches or anything else.
Re: Lower handlebars for sub mount
Posted:
Sat Dec 10, 2016 8:17 pmby Volitans
Tks guys, i ordered the evo damper low bar. Jump64, are you finding it hard to mount handguards etc with the low bars and brp mount?
Re: Lower handlebars for sub mount
Posted:
Sun Dec 11, 2016 12:17 pmby jump64
Nope not at all, using Cycra probends with BRP bar mounts.
https://www.brpmoto.com/new-products/pr ... -9254.html
Re: Lower handlebars for sub mount
Posted:
Sat Feb 04, 2017 6:35 amby Cruiser
I have the evo low, the brp mounts and find the cycra pro bends sit just a bit high or just look off. Has anyone come up with something for this? or ran into this? I really like the cycra guards. Thinking of making a spacer that will allow the inner to mount 1.5 cm lower would fix everything, but there has to be an easier solution.