Beta wheel set swap

[Dave399]

Hey guys,

I’ve seen some posts about this topic being possible and fairly simple, i want to use my 2017 Beta 300 wheelset on my 2017 Ktm 250sx. I do not have the best measuring tools, but taking what I found and reading some stuff on here, this is what I think willl work and pleas correct me if I am wrong or there is an easier way

Front- just use Ktm spacers and it will fit perfectly
Rear- put Ktm rotor on beta hub, keep stock beta sprocket on hub. Modify beta wheel spacers by cutting and removing the section that inserts into the bearing. Machine the ID of spacers to accept Ktm axle. Fabricate an additional spacer to insert between wheel spacer and brake caliper carrier (2.5 mm ?)

Thank you for the insight
Dave