Beta Riders Club Discussion Forum

Hi,
I am replacing the triple clamp on my 2021 250rr and need to carry over the bearings from the existing triple clamp.
The bearing on the lower tripple clamp sits very tight around the axle and am not sure what would be the way to remove it without causing any damage.

Your help and recommendations is greatly appreciated.
Thank you!
Ariel

Buy a new set.. removal is destructive. I don't see a way of not distorting the cage without some tricky puller I've never seen . Usually this isn't a concern as you are replacing a buggered set.

the only way I can think of is to press the stem out of the bearing and clamp together