How to remove the bearning from the lower triple clamp?
Posted: Fri May 27, 2022 11:49 am
Hi,
I am replacing the triple clamp on my 2021 250rr and need to carry over the bearings from the existing triple clamp.
The bearing on the lower tripple clamp sits very tight around the axle and am not sure what would be the way to remove it without causing any damage.
Your help and recommendations is greatly appreciated.
Thank you!
Ariel
I am replacing the triple clamp on my 2021 250rr and need to carry over the bearings from the existing triple clamp.
The bearing on the lower tripple clamp sits very tight around the axle and am not sure what would be the way to remove it without causing any damage.
Your help and recommendations is greatly appreciated.
Thank you!
Ariel