gasgastrials wrote:If you have a look on the JD Jetting site you will see my bike, with a 2013 KTM wheel and street tire, on his dyno. It will fit, but as you noted, the disc will not. No info on the front.
That's great info, thanks. If you have used a 2013 wheel then my 2011 wheel my not fit due to rear axle diameter and I shall need to swap the rear spacer bushes as I believe that the bearings are the same. That sounds like a winter project.
From what I picked up on the UK KTM forum, trying to fit a KTM front wheel is a world of pain. The front disk is very similar, the only main difference is the position on the speedo trigger magnet. It is about 10mm further away from the centre on the Beta and may be too far out to trigger the pickup. Another project, I think.
2020 200RR.
2014 300RR. Gone but not forgotten.