Clake SLR

Clake SLR

Postby the sloth » Sat Nov 21, 2020 9:16 am

Today I switched out my Clake 2 and installed my Clake SLR dual control on my 2020 Beta 300 RR RE with Nissen brakes and after succesfully bleeding the system I thought all was well but after a test ride I noticed that the position of where the brake lever made contact would change. The first pull would result with the lever coming within about 1 1/2 inch of the bar but if I released it and reapplied the brake again the lever would not need to be pulled in as far before making contact. In both positions of contact there is a very solid contact, there is no bleed down if the lever was held in while contacting the pads.
I tried messing with the plunger setting and could achieve consistent lever position even after several pulls but then the brake feels as if it's dragging.
Any ideas?
the sloth
 
Posts: 14
Joined: Thu Dec 07, 2017 8:34 am

Return to Other..

Who is online

Users browsing this forum: No registered users and 14 guests