P3 Frame Grip Guards for '17 300rr

[Jebster]

Turned out even nicer than I imagined . . . they stick VERY well; some sort of weave with a grip layer on the surface. Should wear well - I'll report back after some seat time.

P3 also makes a plug kit for the swingarm ends and rear axle ends.

[nevermind]

sweet!!!

[Hoosier-Daddy]

Turned out even nicer than I imagined . . . they stick VERY well; some sort of weave with a grip layer on the surface. Should wear well - I'll report back after some seat time.

P3 also makes a plug kit for the swingarm ends and rear axle ends.

Any word?

[little_wing]

hows the riding and time review on this????
we used to use skate board grip tape off the roll to do this years ago.. the "sand" of the grip tape would wear out and we would have to try and remove the grip tape then reapply.
this video is not me but its what we use to do
warning don't listen round young ears... swearing
https://www.youtube.com/watch?v=Z9sJT4Xbr7I

Turned out even nicer than I imagined . . . they stick VERY well; some sort of weave with a grip layer on the surface. Should wear well - I'll report back after some seat time.

P3 also makes a plug kit for the swingarm ends and rear axle ends.

[Glenn]

Will it fit a 480 or is there a specific one made for the 480. I think the guard looks pretty darn good.

[Jebster]

Initially I reinstalled the OEM frame guards over the grip guards. A good combo - the grip guards cover the upper frame tube and the OEM frame guard the lower units.

Then I removed the OEM guards to monitor wear. Here they are after roughly 20hr. I'm thinking about trimming away unneeded portions of the OEM guard and reinstalling.

[Jebster]

Will it fit a 480 or is there a specific one made for the 480. I think the guard looks pretty darn good.

I believe so, they are advertised as "RR/RS 10-17"

http://www.ktm-parts.com/AOMC/product/749060?gclid=CNvJyfzMsdICFRS4wAodiQoFHw

[Glenn]

Cheers and thanks Jebster.

[nevermind]

Just a note on durability vs. price. One of my P3 frame guards is sticking on and fully intact. The other lost the protective plastic/polymer coating over the fancy color background. I have been running both of my plastic frame guards from Beta, there just isn't enough protection from those strips.
Won't do these again...

[Darkside]

when your guards get so fancy that you need guards for your guards. somethings wrong.