Beta Riders Club Discussion Forum

Just a FYI. I am new to beta and when I got the new 390rr it had enduro engineering brace on it. I was looking at getting a fan kit and found out that ee did not make there brace to accept any fan kits. I am very disappointed with this news and looks like I will be modding the braces very soon. If these were not already installed I would not buy them. Just a heads up.

Thanks for the heads up. I have the same braces on my 300 but no fan as of yet. Please keep us informed on how you mod them to work in harmony.

Thanks for that heads-up, Dan.

I was shopping around for radiator braces for my 390RR and didn't know that about the EE braces, and I was actually considering them. I ended up going with the Unabiker braces, which are solid even though I haven't installed them yet. I understand they will accommodate a fan with no problem.

When I install the Unabiker braces, I'm going to also install this Spal puller fan that came recommended by a member over at TT. Supposed to be a high volume solid fan. https://www.amazon.com/Spal-30103018-Pa ... puller+fan

I'll post up once my install is finished. Probably not for another couple of weeks.

We're talking guards here not braces right?
I have Unabikers and they will accommodate the fan. The best guards I've seen though are the Bullet Proof Designs ones. Chris has them on his 500. When and if I have to replace mine, I'll be going Bullet Proof.

This is the Enduro Engineering radiator brace for 250/300


I have a 300 and the original post was about a 390. EE states the the brace was designed to fit the factory BETA fan kit for 250/300. Maybe something is different on the four strokes.
http://www.enduroeng.com/index/beta-250 ... races.html



They also sell a guard that bolts to the front of the brace.

the 4st braces do look different then the 2st.