Page 2 of 3
Re: EE Rad Guards 300RR
Posted:
Wed Mar 26, 2014 8:22 amby Darkside
twowheels; you sell your own brand or ? If it's the Beta accessory that is on the AmBeta site the instructions on their support site show having to move the rectifier.
I just installed Am Beta guards. filed the little tit on the rectifier and rotated a few degrees. No big deal.
Re: EE Rad Guards 300RR
Posted:
Wed Aug 27, 2014 1:36 pmby flybars
I have the ambeta rad guards thru byob program. Has anyone here added a front grill to these guards yet? I wonder if Steves grills would work? Any suggestions welcome.
Re: EE Rad Guards 300RR
Posted:
Tue Oct 14, 2014 1:39 pmby jump64
Thanks for the helpful information, made my install much smoother.
As a side note on the 2015 did not have to move the rectifier there was enough clearance, and used the stock horn mount.
I did have to trim the inside edges of the radiator shrouds and the louvers to fit.
Re: EE Rad Guards 300RR
Posted:
Tue Oct 14, 2014 6:00 pmby Calgarytrev
I went ahead and bought two wheels rad guards, I'll post a pic when they arrive this week to compare the two
Re: EE Rad Guards 300RR
Posted:
Tue Nov 18, 2014 4:41 pmby ks9mm
My EE rad and hand guards were installed by dealer before I picked up the bike..
Since my bike is pretty prone to falling down..I am confident that they are now well tested. So far so good.
Re: EE Rad Guards 300RR
Posted:
Mon May 04, 2015 5:30 amby mikl525
Did you have any issue with the radiator fairing and having to trim the inside of it to fit around the EE guard?
Re: EE Rad Guards 300RR
Posted:
Mon May 04, 2015 12:20 pmby ks9mm
Dealer installed mine, so I am not sure if there were any issues. I do not see anything being trimmed other than rectifier repositioned.
Re: EE Rad Guards 300RR
Posted:
Mon May 04, 2015 1:37 pmby Enmerdeur
mikl525 wrote:Did you have any issue with the radiator fairing and having to trim the inside of it to fit around the EE guard?
I think I only had to trim the louvers. Didn't have to touch the shrouds.
Re: EE Rad Guards 300RR
Posted:
Thu May 07, 2015 8:01 pmby mikl525
Enmerdeur wrote:mikl525 wrote:Did you have any issue with the radiator fairing and having to trim the inside of it to fit around the EE guard?
I think I only had to trim the louvers. Didn't have to touch the shrouds.
Okay thanks. Are you running the bottom bolt or using the rubber strap that some EE guards tend to use? My shrouds will need to be trimmed on the inside to make them sit flush it looks like.
Re: EE Rad Guards 300RR
Posted:
Fri Jun 26, 2015 8:26 amby pguerci
Does the cooling fan still fit in the right hand rad when using these EE braces? It should seat at the very bottom part of the rad but I see in the picture that' it is occupied with the brace. Then fitting the fan about an inch higher not sure if will cause an problem with the gas tank.
Anyone tried these EE guards also with the cooling fan installed? (this doesn't seam to be an issue with the AmBeta rad guards)
I'd like to order one of these, like them...