Beta Riders Club Discussion Forum

http://www.mooseracing.com/products/?productId=166503
picked it up for 44 CND
Moose racing part number 1602-1057
same length as stock
better spring in the tip as its stainless steel and stronger,
much more grip on the tip.
comes with new 8mm bolt.
The forged shift lever arm is manufactured from aircraft grade 6061 aluminum
Made for moose by Hammerhead.
I like it but I have not rode with it yet that will be this weekend

Nice find shame they don't make a shorter one.

Marty Moose wrote:Nice find shame they don't make a shorter one.

they do. but it does not say " made for beta"
the 2008 Honda 250 shifters. I think its the CR that is the same just a bit shorter or closer to the foot peg.

so if you got the same type of shifter from moose but for that bike it would be shorter

little_wing wrote:

Marty Moose wrote:Nice find shame they don't make a shorter one.

they do. but it does not say " made for beta"
the 2008 Honda 250 shifters. I think its the CR that is the same just a bit shorter or closer to the foot peg.

so if you got the same type of shifter from moose but for that bike it would be shorter

Yep I have one it sticks out further from the cases I just trimmed the tip a little.

Marty Moose wrote:

little_wing wrote:

Marty Moose wrote:Nice find shame they don't make a shorter one.

they do. but it does not say " made for beta"
the 2008 Honda 250 shifters. I think its the CR that is the same just a bit shorter or closer to the foot peg.

so if you got the same type of shifter from moose but for that bike it would be shorter

Yep I have one it sticks out further from the cases I just trimmed the tip a little.

This is my problem. I keep hitting the arm of the lever and not the folding tip due to it sticking so far out from the cases.

Yup, I have that shifter and like it, much stronger than that stock design. Correction...I don't have lever#1602-1057, but I do have short moose lever for X-trainer with no holes in the lever. That one is strong. I had the other hammerhead lever that looked like stock but that one bent easily.