Beta Riders Club Discussion Forum

Almost every video out there to watch on YouTube about replacing wheel bearings is laughable, but recently found a handy tool in the process. “Wheel bearing press tool” for sale by YouTuber “Tokyo Offroad.” Made for KTM’s but fits Beta too. In my opinion, it’s the best tool for the job and the only one of its kind for dirt bikes. It only took a week to get to me in the US from Japan.

I worked with mark (toykooffroad) to design the beta oil change tool. it works mint
and I have the steering stem tool that he makes
all are nicely machined and work mint

Ive never had a problem with using a piece of brass and tapping the bearing in off of the outer race. If you are concerned about straightness of the bearing going in just go to your local machine shop with the bearing and tell them you want a piece of 1/4" flat stock with a slip fit for the supplied bearing. Then use that as your guide while installing.

little_wing wrote:I worked with mark (toykooffroad) to design the beta oil change tool. it works mint and I have the steering stem tool that he makes all are nicely machined and work mint

That oil drain tool is a great bit of kit. With it I can easily do a complete 2T gearbox oil change in under 10 minutes with no mess or need to remove the skid plate etc.

wwguy wrote:

little_wing wrote:I worked with mark (toykooffroad) to design the beta oil change tool. it works mint and I have the steering stem tool that he makes all are nicely machined and work mint

That oil drain tool is a great bit of kit. With it I can easily do a complete 2T gearbox oil change in under 10 minutes with no mess or need to remove the skid plate etc.

thank you sir. its the right tool for the job

Just checked the manuals, it fits every Beta from ‘13 on EXCEPT the 125 4-stroke. Not sure about the new ‘19 200 2T or supermoto hubs since I can’t find anything on them