What size bars do you have ? Do you know ?

[Dirt Dud]

Measure from the farthest outside points .

[Goatse]

Mine are stock, but I have been meaning to take the width of my hand guard bar off of each side.

[oldman]

I ride tight woods. Cut my naked bars to 29 inches. With bark busters installed they usually measure 30 inches tip to tip.

[Cruiser]

With bark busters I'm at 31.5 but Drew did tell me that. That was back in the day when we all would cut bars down to stupid widths. Best way to figure out how wide your bars should be is by doing pushups. Figure out where your hands are most comfortable doing that and have someone measure your hands, outside palm to outside palm. Thats your bar measurement. Smaller wingspan guys will have closer bars. I should have a 30" but find the 31 feels better in rough whoops. I'm only 5'6" so I don't have the reach some of you guys do.

[Darkside]

I have so many gadgets on my bars now with lhrb, map switch and kill button I have to run full stock width

[moto367]

what bend are the stock bars closest to? I used to cut them down but anymore there are no tight enduros so I leave them at stock width.