I have a MY 2016 RR250 racing with approx 10 h run time.
Fork and shock clickers are set as the factory specs
Rider 62 kg moderate pace rider.
I have installed the fastway protection link in the lowest position ( lower by 15 mm) for compensating on the front I also raised the forks to the third line ( approx 9-10 mm)
Sag settings
Fork
Bike sag 36 mm with rider it drops to 44 mm
Shock
Bike sag 38 mm with rider it drops to 105 mm
Are these values correct for me ?
I only use less than 2/3 off the fork travel ( used a ty wrap to get the max distance)
In the rear I seem to get the correct sag setting but don't know how much off the shock travel I am using here.
Also the fastway link is stiffening up the first part off the shock travel ( said so on the instruction sheet)
Are the values correct or do I need a different spring rate ( forks, shock)
Best,
David