by TCretro » Tue Nov 09, 2021 12:35 pm
That is what I am assuming but this is directly from the manual:
1) Keep the vehicle in vertical position
relative to the ground.
2) Position the drive on a flat base ensuring
stability.
3) Start the engine and keep it running for
about 2 minutes.
4) Keeping the engine idling, check that the
oil level reach middle of the of the inspection
window 1.
5) If the level is below the edge of the window,
switch off the engine and top up
through the filler hole 2. Load oil until it
reaches the upper edge of the window.
6) Close the filling hole with the plug 2 and
repeat steps 3, 4 and 5 until the condition
in step 4 is satisfied.